Professional

Leading

Service Hotline
+86 136-9170-9838
[→] Enquire Now
Close [x]
Flux Flux
Flux - Water-soluble flux 704
Water-soluble flux 704

For reference only, subject to actual

Water-soluble flux 704 Introduction

Unibright 704 lead-free water-soluble flux is specially designed for automatic welding equipment with a water washing process. This product does not contain rosin and has little corrosion to the metal surface of the plate and welding equipment; The welding process produces less smoke and no irritating odor; The water cleaning effect is good, the solder joints are full and bright, and the solder joint strength is high. For high-quality and stable welding operations in electronic product production, this product can meet the requirements.

Water-soluble flux 704 Product Features

➤ This product does not contain rosin and has little corrosion to the metal surface of the board and welding equipment.
➤ The welding process produces less smoke and no irritating odor.
➤ The solder joints are full and bright, with high strength.
➤ Good water cleaning effect, combined with spray/ultrasonic cleaning, can quickly clean and achieve extremely low ion residue.
➤ For high-quality and stable welding operations in electronic product production, this product can meet the requirements.

Water-soluble flux 704 Applicable process

The application method of Unibright 704 lead-free water-soluble flux can be coating or impregnation, with good process adaptability.

Water-soluble flux 704 Application

➤ The service life of soldering flux varies slightly due to process conditions. When the flux is not in working condition, it should be kept in a sealed container as much as possible to avoid solvent evaporation.

➤ When it is necessary to replace expired flux, the flux container should be thoroughly cleaned before replacing with a new flux.

➤ Pre heating after application of flux can fully leverage the advantages of Unibright 704 lead-free water-soluble flux. It is recommended that the preheating temperature should reach 100-150 ℃ on the PCB board or component welding surface after preheating.

➤ Using hot water at 50-60 ℃ combined with spray/ultrasonic cleaning can achieve the minimum ion residue without the need for any cleaning agent.

Application of Unibright products

💧If you cannot find the information you need, please contact customer service +86 136-9170-9838
[ico] 💬
Service hotline
Service hotline:
Enquire
Online consultation:
Enquire
Contact Us
[↑]
Application
[x]
*
*
Marked with * is mandatory